Spray booth consideration :
Spray booth only allowed using no risk of explosion and open flame ,smoking is strictly prohibited within 10 meters of the baking room or barn outsideSpray booth inside shall not store flammable and explosive materialsEach time the job is completed ; clean-up must be carried out to the spray booth ,all the material for painting must be taken out .The supply voltage shall not be lower than or higher than 10% of the specified voltage .Without the approval of the manufacturer unauthorized changes all liability caused by the equipment manufacturer no responsibilityAll liability caused by the removal and tampering protection of the safety devices without authorization, the manufacturer takes no responsibilityThe device working ,someone must monitor ,all parking position switch must be reset after work .Housing Mainland grille hosts the work-piece ;tread plate carries only the weight of the operator ,not carrying the weight of the work-piece .The ground network and its room ground recommended weekly with a vacuum cleaner to clean once Spray booth with mosquitoes ,should repellent drugs remove mosquito to paint operation.The device must be operated by professionals familiar with the operation of equipment specification .Equipment before use should open the system used in the no-load Preheat run for 20 minutes, in order to avoid adverse effects on the work-piece .
Specification :
| Outside size: | 7000 x 5350 x 3400 mm (L x W x H) | Door size: | 3020 x 2600 mm (W x H) |
| Inside size: | 6900 x3900 x 2700 mm (L x W x H) | Gross power: | 39(KW) |
Foundation and floor
(galvanized) | Foundation | Full galvanized metal foundation, two rows of grids and three rows of metal non-slip diamond plates |
| Surface area of floor filter | 10 M² (area of grids) |
| Galvanized metal basement | 300mm height, the ventilation effect is better than traditional spray booth |
| Drive-in ramps | 2 big drive-in ramps, each size: 2000x630mm |
Wall and door
(EPS) | Wallboard and roof panel | Side wall panels adopt high quality double construction fireproof EPS insulation materials, thickness is 50mm, Roof panels adopt galvanized steel plate bending forming |
| 3-folded entrance door with safety glass window | 1set, size: 3020x2600 mm (W x H), size is bigger than traditional spray booth |
| Operator's door with safety glass window | 800x2000mm(W x H) |
| Lighting | Ceiling lighting | 8units, each 3 x 36W, total 860W |
| Side lighting | / |
| Brightness | ≥700 LUX |
| Filtration system | Pre-filters | G2 grade plate type filter |
| Ceiling filter | EU5 grade high efficient filter |
| Bottom filter and exhaust filter | Fibre glass paint-stop filter |
| Ventilation system | Inlet fan | 2 x 4KW, 380V, 50HZ, CE, Double intake centrifugal fan |
| Outlet fan | / |
| Total fan capacity | 25,000m³/h |
| Air flow speed in cabin | 0.25m/s in empty booth, 0.26 - 0.3m/s in loaded booth |
| Heating system | Temperature | Set temperature 60ºС, max baking temperature is 80°C |
| Heating Type | 10 units infrared heaters, total 30KW |
| Heating time | 4-6minutes (from20 to 60ºС) under baking status |
| Control board | Control system | Standard direct start control system |
| Function | Painting, infrared baking, lighting, emergency stop switch, failure indication |
){kind=link}